A quick guide on best practices for installing your Bosch home appliances

Installation methods and measurements may vary from model to model – check the installation manual or consult your contractor for more details.

Exhaust outlets for vented dryers

*Please note that this is only applicable to vented dryers.

1. Condensation outlet

Condensation outlet

  • If there is a high level of condensation in the exhaust air duct, it is advisable to fix a condensation collector (standard) or a drain hole with a diameter of approximately 3mm to the lowest part of the exhaust air duct.
  • Outlets for the exhaust air duct are located at the back and left side panels of the dryer. Please note that this is only applicable to vented dryers.

2. Left side panel outlet

Left side panel connection

Step 1: The exhaust port on the left side panel is sealed with a removable cover.

Step 2: Twist the cover on the side panel in an anti-clockwise direction to loosen and remove it.

Step 3: Twist the bayonet ring on the back panel in an anti-clockwise direction to loosen and remove it. Attach the ring to the side panel exhaust port by turning it in a clockwise direction.

Step 4: Attach the panel cover to the back panel and twist in a clockwise direction to seal the exhaust port.

3. Back panel outlet

  • The exhaust port on the back panel is open when the dryer is delivered (bayonet ring).

Installation options for the exhaust air duct

1. Through a wall into the open air

Through a wall into the open air

  • Run the exhaust air duct in a way that ensures that the moist air expelled does not get drawn in by the dryer again.
  • The duct should spread out with a 90 degree bend to prevent air backflow, with the end part of the duct facing downwards to the floor.
  • The end section of the duct should not be more than 2.5m higher than the exhaust port on the appliance.

Example:

Pipe connection - inside diameter = 100mm, smooth

A = straight piece

B = curved pipe

C = straight piece

D = pipe elbow

E = telescopic wall box with grid

2. Through the open window

Through the open window

  • Route the exhaust air directly into the open air via an exhaust air pipe through an open window.

Example:

Pipe connection - inside diameter = 100 mm, flexible pipe, corrugated

A = curved pipe

B = straight piece

C = curved pipe

D = straight piece

Installation of stacking kit

* This is applicable to both condenser and vented dryers.

1. Install the stacking kit

1. Locate the holes that need to be drilled into the washing machine for mounting the stacking kit.

2. Drill holes based on the markings made and secure the stacking kit on top of the washer with the screws.

2. Adjust the height of the appliance feet

1. Using the template provided, adjust the height of each foot of the dryer.

2. Remove the brackets on both sides of the stacking kit.

3. Stack the dryer on the washer

1. Place the dryer on top of the washing machine and slide in via the groove of the stacking kit.

2. Place back the brackets and secure with the screws provided

Instruction Manuals

Download our manuals to help you get a quick start to operate your appliance.

Our service

Outstanding service – before and after the purchase.

+62 821 11660377

Experience Bosch

Discover quality, perfection, and reliability.

Find a dealer

Find dealers or service shops near you!