A quick guide on best practices for installing your Bosch home appliances

Installation methods and measurements may vary from model to model - check the installation manual or consult your contractor for more details.

Removing the transport locks

  • Before using the appliance for the first time, make sure that you completely remove all four transport bolts.
  • To prevent transport damage from occurring if the appliance is moved at a later date, you must refit the transport bolts.

Removing the transport locks

Step 1: Take the hoses out of the holders.

Step 2: Unscrew and remove all four transport brace screws using a WA17 wrench.

Step 3: Remove the sleeves. To do this, remove the mains cable from the holders.

Step 4: Fit the covers. Lock the covers firmly in place by applying pressure to the snap-in hooks

Leveling

Level the appliance using a spirit level. Incorrect leveling may result in intense noise, vibrations and "wandering"

1. Loosen the lock nuts using a WA17 wrench, by turning it in a clockwise direction.

2. Check the alignment of the washing machine with a spirit level and adjust the height of the appliance feet if necessary. All four appliance feet must stand firmly on the ground.

3. After adjustment, hold the foot firmly and tighten the lock nuts with the WA17 wrench by turning in an anti-clockwise direction.

Left-hand and Right-hand Connections

The washing machine can be connected to the water inlet and outlet either on its left or right side.

The following water inlet accessories are available from customer service:

- An extension for Aqua-Stop or cold water supply hose (approx. 2.50m) if available.

- A longer supply hose (approx. 2.20m) for standard model

Water can be discharged via a siphon, sink, stand pipe or gully.

1. Left-hand connection

2. Right-hand connection

1. Water Connection

1. Connect the water supply hose to the water tap (3/4” = 26.4 mm) and to the appliance.

2. Open the water tap carefully, checking for the leakages and tighten if necessary.

2. Drainage into a wash basin

If the attached drainage hose slips out of the washbasin due to high water pressure when draining the washing machine, leaking water may cause damage. Secure the drainage hose to prevent it from slipping out of the sink.

If the end of the drainage hose is immersed in the drained water, water may be drawn back into the appliance!

  • The plug must not be in the plug hole.
  • When the water is being pumped out of the washing machine, check that the water drains away quickly enough.
  • The end of the drainage hose must not be immersed in the drained water.

3. Drainage into a siphon

If the drainage hose slips off the siphon connection due to high water pressure when draining the washing machine, leaking water may cause damage. Connection point must be secured with hose clip, Ø 24–40 mm

4. Drainage into a plastic pipe with rubber sleeve or into a gully

If the drainage hose slips off the plastic pipe due to high water pressure when draining the washing machine, leaking water may cause damage. Secure the drainage hose to prevent it from slipping out.

Instruction Manuals

Download our manuals to help you get a quick start to operate your appliance.

Experience Bosch

Discover quality, perfection, and reliability.

Find a dealer

Find dealers or service shops near you!

Our service

Outstanding service – before and after the purchase.

+62 821 11660377